![]() In this diagram, there is a Cable Modem Termination System (CMTS) that consists of these components: Lab Topology Figure 1 – Lab Network Setup Conventionsįor more information on document conventions, refer to the Cisco Technical Tips Conventions. If your network is live, make sure that you understand the potential impact of any command. All of the devices used in this document started with a cleared (default) configuration. The information in this document was created from the devices in a specific lab environment. There are no specific requirements for this document. However, this procedure can be used to rule out issues that arise from the Cisco IOS® Software Release, the configuration, the hardware, and Radio Frequency (RF). In a controlled lab environment, noise may not be an issue while in real life, it can be quite the opposite. ![]() It is important to note that a trouble-free setup in the lab does not necessarily mean a trouble-free setup in a customer’s network. This setup can be used as a first step before deployment to a customer network. The purpose of this tech note is to provide a complete setup guide for a cable modem (CM) network in a lab environment. ![]()
0 Comments
|
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |